The Invisiware® Receiver with Invisiware® Stud combination is a concealed, swaged, tensioning, through-the-post-mounted fitting that is suitable for level runs. Receivers and studs are available for 1/8”, 3/16”, 1/4”, 5/16”, and 3/8” diameter 1x19 stainless steel cable; 1/8” and 3/16” sizes are also suitable for pitched applications.

FOR METAL POSTS
The Invisiware® Receiver with Invisiware® Stud can be used with any other fitting on the opposite end of the run. This fitting is placed and concealed within a pre-drilled hole in the metal end post. The Receiver is furnished with a Delrin® washer that is installed between the shoulder of the fitting and the end post to protect the surface of the finish of the end post as tension is applied. The stud is swaged onto one end of the cable and is inserted and threaded into the Receiver installed in the end post. Tension is created by rotating the Receiver (with a hex wrench inserted into its broached end) and drawing the Stud into the Receiver.

This fitting in 1/8” and 3/16” cable sizes can also be used in pitched applications using the same method (including a horizontally drilled hole) described previously. This fitting is commonly paired with a Pull-Lock® on the opposite end of the run.

Choose Invisiware® Stud item S-6

FOR WOOD POSTS
The Invisiware® Receiver with stud can be used with any other fitting on the opposite end of the run. This fitting is placed and concealed within a pre-drilled hole in the wood end post (a minimum of 3” of clearance must exist on the back side of the post to allow installation of the Receiver). We recommend placing a stainless steel flat washer between the fitting shoulder and the mating surface of the wood post (washer sold separately, see bottom of page). The stud is swaged onto one end of the cable and is inserted and threaded into the Receiver installed in the end post. Tension is created by rotating the Receiver (with a hex wrench inserted into its broached end) and drawing the stud into the Receiver.

This fitting can also be used in pitched applications using the same horizontally drilled method for 4x4 wood posts. The same method works for larger posts by installing a post protector tube on the cable exit-to-pitch side of your wood end post. This fitting is commonly paired with a Pull-Lock® on the opposite end of the run.

Choose Invisiware® Receiver item R-6-62 for wood posts.

Choose Invisiware® Stud item S-4

Use Stainless Steel Washer 7/16SAE on wood posts

Use Post Protector Tube CS TUBE on wood posts that are on an angle