Small carriage with 5 nylon rollers for aluminum track

Small aluminum track to be used with CGA-350.5M carriages.

Measures 3-1/4" W x 3-1/8" H x 9'10" Long

The aluminum alloy used for this track is AW-6060 T5 EN 573-1.

One of our customer service representatives will contact you in regards to shipping your item.

In order to ship UPS, track must be cut to no more than 7'9" feet. There is a $10.00 per cut charge.

Small aluminum track to be used with CGA-350.5M carriages.

Measures 3-1/4" W x 3-1/8" H x 19'8" Long

The aluminum alloy used for this track is AW-6060 T5 EN 573-1.

One of our customer service representatives will contact you in regards to shipping your item.

End wheels serve three functions:

1)     covering the end of the track for UL325 compliance when the gate is automated,
2)     assisting the gate to seat effortlessly into the end cup receiver to stabilize the gate in the open and closed positions, and
3)     keep dirt and debris out of the track for smoother operation.

End cups are used to stabilize the gate in the fully open and closed positions AND to provide a positive gate stop to meet safety code for automated gates. Typically 2 are used per gate. For gates that stay closed most of the time only 1 is needed.

Foundation Plates make it easier to level and align the carriages, but are not required.

Foundation Plates make it easier to level and align the carriages, but are not required.

J-Bolts set into newly poured concrete are the best method of anchoring the carriages to the pad.

Mini carriages require 4 J-Bolts per carriage. 

Large, Grande & Extra Large carriages require 6 J-Bolts per carriage