Small Primary/Secondary 8-wheel carriage set.

Driven by primary carriage.

Small galvanized steel track to be used with CGS-500.8M carriages.

Measures 2-3/4" W x 2-3/4" H x 9'10" Long

One of our customer service representatives will contact you in regards to shipping your item.

In order to ship UPS, track must be cut to no more than 7'9" feet. There is a $10.00 per cut charge.

Small galvanized steel track to be used with CGS-500.8M carriages.

Measures 2-3/4" W x 2-3/4" H x 19'8" Long

One of our customer service representatives will contact you in regards to shipping your item.

In order to ship UPS, track must be cut to no more than 7'9" feet. There is a $10.00 per cut charge.

This gear rack mounts to the top, inside the galvanized track completely hiding the drive system. The gear in the primary carriage drives the track and the gate with no exposed hardware for complete protection.

This gear rack is 4'11" long and comes with mounting screws.

End wheels serve three functions:

1)     covering the end of the track for UL325 compliance when the gate is automated,
2)     assisting the gate to seat effortlessly into the end cup receiver to stabilize the gate in the open and closed positions, and
3)     keep dirt and debris out of the track for smoother operation.

End cups are used to stabilize the gate in the fully open and closed positions AND to provide a positive gate stop to meet safety code for automated gates. Typically 2 are used per gate. For gates that stay closed most of the time only 1 is needed.

J-Bolts set into newly poured concrete are the best method of anchoring the carriages to the pad.

Mini carriages require 4 J-Bolts per carriage. 

Large, Grande & Extra Large carriages require 6 J-Bolts per carriage

Foundation Plates make it easier to level and align the carriages, but are not required.

This coupling connects the output driveshaft of the gate operator directly to the input driveshaft on the primary carriage. This gives a direct, secure and safe connection between the motor and the gate.

Use with Integrator models CGS-500.8M and CGS-500.8P

This drive shaft coupling will be used if the DEIMOS gate operator, by BFT, is used to automate the sliding gate.

Use with Integrator models CGS-500.8M and CGS-500.8P

This drive shaft coupling will be used if the ARES gate operator, by BFT, is used to automate the sliding gate.

Use with Integrator models CGS-500.8M and CGS-500.8P

This drive shaft coupling will be used if the FAAC 844ER gate operator is used to automate the sliding gate.

Use with Integrator models CGS-500.8M and CGS-500.8P

When used in conjunction with the CG-58 coupling, this allows a typical chain drive gate operator to be used to drive the Duragates Integrator carriage to open, close, and control a cantilever slide gate.